VK3RMH
70cm
FM voice repeater

Frequencies:
433.325MHz
input, 438.325MHz
output
Access Tones: None required for
access.
123Hz CTCSS on output can be used for tone squelch.
Power:
25 Watts
Antennas:
4
dipole vertical omnidirectional array
Radio:
Aging Philips FM815 series crystal locked RX and TX
Controller:
Home
Brew 8748 microprocessor based
Echolink node 140587
Send
DTMF '73' to disconnect after use!
+
Please check that the repeater is not in use BEFORE using IRLP or
Echolink.
+
Always announce your callsign and intention to make an Internet connection BEFORE
opening a connection.
+
Users must identify themselves by announcing their callsign once a
connection is made.
+
The system chops off the first and last second of each over -
please wait 2
seconds after key up before talking, and wait 2 seconds before
releasing PTT at end of each over.
+
IRLP and Echolink must not be used to extend an amateur's operating
privileges where the node is located.
+ Always check that the remote
node's output frequency falls within your licence conditions.
+
Third party traffic is permitted only if there is an agreement between
Australia and any other country involved.
+
Repeat CQ calls more than once if no answer - often people are
listening but
need time to reach the microphone!
For more information on IRLP visit the IRLP web site at www.irlp.net
For more information on Echolink visit www.echolink.org

The
VK3RMH amateur radio
repeater
serves the outer
North-Eastern suburbs of
Melbourne, Victoria, Australia
VK3RMH is owned and operated by the NERG -
the North
East
Radio Group, Inc.
NERG is a
group of amateurs interested in the friendly
and fun aspects of amateur radio activities.
For
more information, please send
email to: vk3rmh
nerg.asn.au
North East Radio
Group, Inc. Melbourne, Australia. updated 5 Nov 2008 vk3byy
